SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof Assembly
INSTALLATION
CAUTION:
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
• For installation of the stereo camera cover assembly, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION">
• Be careful not to snag the harness.
1. Install each connector and the drain tube - sunroof.
Tightening torque:
Connector holder: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Ground bolt: 13 N·m (1.33 kgf-m, 9.6 ft-lb)
2. Install the sunroof bracket and the rail assembly - sunroof.
Tightening torque:
6 N·m (0.61 kgf-m, 4.4 ft-lb)
3. Connect the harness connector of the drain tube - sunroof and the motor assembly.
CAUTION:
Insert the four drain tubes 15 mm (0.59 in) or more into the drain pipes (A).
4. Install the curtain airbag module. Curtain Airbag Module > INSTALLATION">
5. Install the bracket - assist rail.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
6. Install the trim panel - roof assembly. Roof Trim > INSTALLATION">
7. Using a new TORX® bolt, install the lid assembly - sunroof.
Tightening torque:
4.5 N·m (0.46 kgf-m, 3.3 ft-lb)
Cleaning aluminum wheels
Promptly wipe the aluminum wheels
clean of any kind of grime or agent. If dirt
is left on too long, it may be difficult to
clean off.
Do not use soap containing grit to
clean the wheels. Be sure to use a neutral
cleaning agent, and later rinse thoroughly
with water. Do not clean the ...
Clear memory mode Operation
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, s ...
List
ENTERTAINMENT > Diagnostics with PhenomenonLIST1. AUDIO SYSTEMSymptomsReferencePower will not turn ON. Diagnostics with Phenomenon > INSPECTION">The screen freezes and does not accept any operation entry. Diagnostics with Phenomenon > INSPECTION">The screen is blacked out, o ...