STARTING/CHARGING SYSTEMS(H4DO) > Battery
INSTALLATION
CAUTION:
After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
1. Install the battery.
2. Set the battery holder and install the flange nut to the battery rod.
Tightening torque:
3.5 N·m (0.4 kgf-m, 2.6 ft-lb)
3. Install the battery cable holder to the battery rod.
4. Connect the positive terminal and then connect the negative terminal to the battery.
NOTE:
Clean the battery cable terminals and apply grease to prevent corrosion as necessary.
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Parking PawlINSTALLATION1. Set the range select lever to the “N” range.2. Install the parking pawl shaft, return spring and parking pawl.NOTE:Make sure that the end of return spring sticks out of parking pawl as shown in (a). Make sure that ...
Removal
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the arm assembly - rear wiper.(1) Remove the cover - rear wiper arm.(2) Remove the nut, and remove the ...
Inspection
FRONT SUSPENSION > Front StrutINSPECTIONCheck the removed part for wear, damage and cracks, and then repair or replace it if defective.1. STRUT1. Check for oil leaks.2. Move the piston rod up and down to check that it operates smoothly without any hitch.3. Check the piston rod runout.Preparation ...