SECURITY AND LOCKS > Rear Outer Handle
INSTALLATION
1. Before installation, check the following items.
• Lever is free from deformation.
• Grease is applied sufficiently to lever joints.
If grease is insufficient, add it as necessary before assembling.
• If the lever is faulty, replace the rear outer handle.
• If the lever is deformed, replace the latch & actuator assembly - rear.
2. Install each part in the reverse order of removal.
CAUTION:
Do not reuse the screws of the latch and actuator assembly - rear. Always replace with a new part.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
Dtc c1362 normal closing valve 2
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1362 NORMAL CLOSING VALVE 2DTC detecting condition:• Defective harness connector• Defective VDCH/U solenoid valveTrouble symptom:• ABS does not operate.• EBD does not ...
Inspection
SECURITY AND LOCKS > Ignition Key LockINSPECTIONPreparation tool:Circuit tester1. Check the resistance between switch terminals.Terminal No.Inspection conditionsStandardBetween all terminals(A)LOCK1 M? or more2 — 4(B)ACCLess than 1 ?1 — 2 — 45 — 6(C)ONLess than 1 ?1 — 3 — 45 — 6 — ...
Dtc p0560 system voltage
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0560 SYSTEM VOLTAGEDTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">, and Inspect ...