Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Rear Gate Latch and Actuator Assembly
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
Removal
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL" ...
Other materials:
Rear windows side seating position
Head restraint
Release button
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks. Press and hold
the release button to lower t ...
Component
SECURITY AND LOCKS > General DescriptionCOMPONENT1. DOOR LOCK ASSEMBLY(A)Front(B)Rear (1)Grommet - screw(9)Key lock - door (driver’s seat only)(17)Frame ASSY - rear door outer(2)Remote ASSY - door(10)Spacer - door handle outer B (3)Cap remote(11)Spacer - door handle outer ATightening ...
Dtc u0427 invalid data received from vehicle security control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0427 INVALID DATA RECEIVED FROM VEHICLE SECURITY CONTROL MODULEDTC DETECTING CONDITION:Defective data was transmitted from keyless access CM.TROUBLE SYMPTOM:Cooperation control of keyless access does not operat ...
