Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator Assembly
INSTALLATION
1. Before installation, check the following items.
• Lever is free from deformation.
• Grease is applied sufficiently to lever joints.
If grease is insufficient, add it as necessary before assembling.
• If the lever is faulty, replace the rear outer handle.
• If the lever is deformed, replace the latch & actuator assembly - rear.
2. Install each part in the reverse order of removal.
CAUTION:
Do not reuse the screws of the latch and actuator assembly - rear. Always replace with a new part.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
NOTE:
Make sure the child safety lock works correctly after installation.
Removal
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL& ...
Other materials:
Removal
SECURITY AND LOCKS > Body Integrated UnitREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait ...
Dtc c0025 rear right abs sensor circuit open or short
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0025 REAR RIGHT ABS SENSOR CIRCUIT OPEN OR SHORTNOTE:For the diagnostic procedure, refer to “DTC C0027 REAR LEFT ABS SENSOR CIRCUIT OPEN OR SHORT”. Diagnostic Procedure with Dia ...
Installation
INSTRUMENTATION/DRIVER INFO > Combination MeterINSTALLATIONCAUTION:• Make sure the electrical connector is connected securely.• Make sure that each meter operates normally.• When the combination meter assembly has been replaced, be sure to perform the following operations.– F ...
