SECURITY AND LOCKS > Front Outer Handle
INSTALLATION
1. Before installation, check the following items.
• Rod is free from deformation.
• Grease is applied sufficiently to rod joints.
If grease is insufficient, add it as necessary before assembling the rod.
• If the lever is faulty, replace the front outer handle.
• If the rod is deformed, replace the latch & actuator assembly - front.
2. Install each part in the reverse order of removal.
CAUTION:
When installing the cover - handle front outer on driver’s side, make sure that the key cylinder shaft is correctly inserted into the latch & actuator assembly - front.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
Dtc u0401 invalid data received from ecm/pcm a
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">1. OUTLINE OF ...
Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle's alarm system for
deactivation mode. Ref ...
Dtc b1908 short in front p/t lh (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1908 SHORT IN FRONT P/T LH (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (LH) circuit is shorted to power supply.• Pretensioner (LH) is faulty.&bul ...