SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator Assembly
INSTALLATION
1. Before installation, check the following items.
• Rod is free from deformation.
• Grease is applied sufficiently to rod joints.
If grease is insufficient, add it as necessary before assembling the rod.
• If the lever is faulty, replace the front outer handle.
• If the rod is deformed, replace the latch & actuator assembly - front.
2. Install each part in the reverse order of removal.
CAUTION:
Do not reuse the screws of the latch and actuator assembly - front. Always replace with a new part.
Tightening torque:
Door lock assembly: General Description > COMPONENT">
Sash COMPL - lower: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorINSPECTION1. CRANKSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)1. Prepare an oscilloscope.2. Remove the glove box. Glove Box > REMOVAL">3. Connect the probe to ECM connector.Terminal No.Probe16+1−4. Start the eng ...
Dtc b2311 rear radar detect tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2311 REAR RADAR DETECT TCMDTC DETECTING CONDITION:Automatic transmission fails.TROUBLE SYMPTOM:• All functions of BSD/RCTA stop.• Fail icon is displayed in the com ...
Dtc b1409 scu communication
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1409 SCU COMMUNICATIONDTC detecting condition:Communication failure between body integrated unit and security control moduleCAUTION:When the body integrated unit is replaced, registration of the immobilizer sy ...