SEATS > Seat Heater System
INSTALLATION
CAUTION:
• If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.
• When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the hog ring.
• When removing or replacing the seat cover, perform “Occupant Detection System Inspection” after installing the seat to check if the occupant detection system operates normally. PRE-DELIVERY INSPECTION (PDI) PROCEDURE">
• If the seat heater module is removed, replace the seat cushion pad & frame assembly with a new part.
• If the seat heater module is reused, remove the polyurethane section from the reverse side completely.
Install each part in the reverse order of removal.
Double-sided tape for seat heater module adhesion:
NITTO DENKO’s 501L or equivalent
Installation
PARKING BRAKE > Parking Brake CableINSTALLATION1. Install each part in the reverse order of removal.Tightening torque:Cable clamp: 18 N·m (1.84 kgf-m, 13.3 ft-lb)Rear wheel: Except for C4 model120 N·m (12.24 kgf-m, 88.5 ft-lb)Rear wheel: C4 model100 N·m (10.20 kgf-m, 73.8 ft- ...
Rear gate - if the rear gate cannot be opened
In the event that you cannot open the rear
gate by operating the rear gate opener
button, you can open it from inside the
cargo area.
1. Remove the access cover at the
bottom-center of the rear gate trim using
a flat-head screwdriver wrapped with vinyl
tape or a cloth.
2. Locate the re ...
Dtc u0101 lost communication with tcm
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM is not transmitted to stereo camera.When lost communication with TCM and TCM abnormal occur simultaneously, perform diagnosis for lost communication ...