Subaru Crosstrek Service Manual: Installation
SEATS > Front Seat
INSTALLATION
Install each part in the reverse order of removal.
CAUTION:
• The front seat mounting bolts differ between the front mounting points and the rear mounting points. When installing the front seat, make sure that you are using correct bolts at correct positions.
• Tighten the slide rail assembly installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.
• Front (bolt A): Washer diameter 22 mm (0.87 in)
• Rear (bolt B): Washer diameter 26 mm (1.02 in)
Tightening torque:
Front seat assembly: 53 N·m (5.4 kgf-m, 39.1 ft-lb)
Inspection
SEATS > Front SeatINSPECTION1. SEAT COVERCheck that there is no tear or fray on the cover COMPL - front backrest and the cover - front cushion.NOTE:For model with side airbag, if the door side of t ...
Other materials:
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)REMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the glove box. Glove Box > REMOVAL">3. Remove the engine control module (ECM). Engine Control Module (ECM) > REMOVAL">4 ...
Removal
EXTERIOR/INTERIOR TRIM > Door TrimREMOVAL1. FRONT DOOR1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - front door.(1) Attach the protective tape (a).(2) Open the cover and remove the screw.(3) Remove the clips, and remove the trim panel - front door from the ...
Check list for interview Check
EyeSight (DIAGNOSTICS) > Check List for InterviewCHECKInspect the following items regarding the vehicle’s state.Writer/InspectorWriter’s name Inspector’s Name Vehicle informationCar accessory equipment conditionCar accessory is installed to the windshield glass.No/Yes(Position: ...
