Subaru Crosstrek Service Manual: Installation
SEAT BELT SYSTEM > Rear Seat Belt
INSTALLATION
1. SEAT BELT OUTER - REAR RH & LH
1. Before installation, perform a unit inspection of retractor. Rear Seat Belt > INSPECTION">
2. Install the seat belt outer - rear.
CAUTION:
• During installation, make sure that the seat belts are not twisted.
• After installation, make sure that the seat belts are smoothly extended and wound.
Tightening torque:
Rear seat belt: General Description > COMPONENT">
3. Install the trim panel - rear quarter trim UPR.
4. Install the remaining parts in the reverse order of removal.
5. After installation, check the following points.
• The seat belt is not twisted.
• The seat belt can be pulled out and retracted smoothly.
2. SEAT BELT - REAR SHOULDER CTR
1. Install the seat belt - rear shoulder CTR.
Tightening torque:
Rear seat belt: General Description > COMPONENT">
2. Install the remaining parts in the reverse order of removal.
3. After installation, check the following points.
• The seat belt is not twisted.
• The seat belt can be pulled out and retracted smoothly.
3. SEAT BELT - CTR RH AND LH
1. Install the seat belt - CTR RH/LH.
Tightening torque:
Rear seat belt: General Description > COMPONENT">
2. Install the rear seat cushion.
3. Install the remaining parts in the reverse order of removal.
4. After installation, check the following points.
• The seat belt is not twisted.
• Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the battery ground cable and turning the ignition switch to ON.
Removal
SEAT BELT SYSTEM > Rear Seat BeltREMOVAL1. SEAT BELT OUTER - REAR RH & LHCAUTION:• Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Be carefu ...
Other materials:
Dtc u0422 invalid data received from body control module
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULEDetected when CAN data from BIU is abnormal.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Charge warning light
If
this light illuminates when the engine is
running, it may indicate that the charging
system is not working properly.
If the light illuminates while driving or does
not turn off after the engine starts, stop the
engine at the first safe opportunity and
check the alternator belt. If the ...
Inspection
SECURITY AND LOCKS > Steering Lock CMINSPECTION1. Check if the steering lock is released when you start the engine using the push button ignition switch.2. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS AC ...
