Subaru Crosstrek Service Manual: Installation

CAUTION:

• Be sure to use a new self-locking nut.

• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1. Install each part in the reverse order of removal.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">

2. Install the rear wheels.

Tightening torque:

Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb)

C4 model: 100 N·m (10.20 kgf-m, 73.8 ft-lb)

Disassembly

Upper arm

Other materials:

Dtc c1431 at
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1431 ATDTC detecting condition:Defective TCMTrouble symptom:• ABS does not operate.• VDC does not operate.STEPCHECKYESNO1.CHECK TCM.1) Start the engine.2) Read the DTC of the TCM ...

Caution
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > General DescriptionCAUTION1. SRS AIRBAG SYSTEMThe airbag system wiring harness is routed near the keyless access with push button start system.CAUTION:• Do not use electrical test equipment on any wiring harnesses and connectors i ...

Installation
LUBRICATION(H4DO) > Engine Oil FilterINSTALLATION1. OIL FILTERCAUTION:Do not tighten excessively, or oil may leak.1. Clean the oil filter installation surface.2. Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.3. Install the oil filter by turning it by hand, being c ...