REAR SUSPENSION > Rear Stabilizer
INSTALLATION
CAUTION:
• Be sure to use a new flange nut and self-locking nut.
• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.
• Install the clamp - stabilizer bushing with the “G” character facing upward.
• When installing, align the edge of identification paint (a) to the end face of the bushing (b).
1. Before installation, inspect the following items and replace any faulty part with a new one.
• Check the bushing - stabilizer for abnormal cracks, fatigue or damage.
• Check the stabilizer link for damage.
2. Install each part in the reverse order of removal.
Tightening torque:
Clamp - stabilizer bushing: 30 N·m (3.06 kgf-m, 22.1 ft-lb)
Stabilizer link: 38 N·m (3.87 kgf-m, 28.0 ft-lb)
3. Install the rear wheels.
Tightening torque:
Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb)
C4 model: 100 N·m (10.20 kgf-m, 73.8 ft-lb)
Inspection
COMMUNICATION SYSTEM > Horn SystemINSPECTIONSymptomsInspection stepsHorn does not sound1. Check the fuse.2. Check the horn relay.3. Check the role connector.4. Check the horn switch.5. Check the horn assembly.6. Check the harness. ...
Passive arming (models without "keyless access with push-button start
system")
Passive arming mode
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the remote transmitter. Note
that in this mode, DOORS MUST BE
MANUALLY LOCKED.
Passive arming mode
When passive arming mode has been
programmed by ...
Audio set
Your vehicle may be equipped with one of
the following audio sets. Refer to the
pages indicated in this section for operating
details.
CAUTION
Always consult your SUBARU
dealer before installing a citizen
band radio or other transmitting
device in your vehicle. Such
devices may caus ...