Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

REAR SUSPENSION > Rear Lateral Link

INSTALLATION

CAUTION:

Be sure to use a new self-locking nut.

Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1. Before installation, inspect the following items and replace any faulty part with a new one.

Visually check the lateral link assembly - rear for damage and deformation.

Visually check the bushing for abnormal cracks, fatigue or damage.

2. Install each part in the reverse order of removal.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">

3. Install the rear wheels.

Tightening torque:

Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb)

C4 model: 100 N·m (10.20 kgf-m, 73.8 ft-lb)

4. Inspect the wheel alignment and adjust if necessary.

Inspection: Wheel Alignment > INSPECTION">

Adjustment: Wheel Alignment > ADJUSTMENT">

CAUTION:

When the wheel alignment has been adjusted, perform the following VDC setting mode.

Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

Model with EyeSight: Neutral of Steering Angle Sensor & Lateral G Sensor 0 point setting VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

Model with EyeSight: Longitudinal G sensor & lateral G sensor 0 point setting VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

5. Perform reinitialization of the auto headlight beam leveler system. (Model with auto headlight beam leveler) Auto Headlight Beam Leveler System > PROCEDURE">

Disassembly
REAR SUSPENSION > Rear Lateral LinkDISASSEMBLYUsing the ST, push out the bushing.Preparation tool:ST-A & ST-B: INSTALLER & REMOVER (20099AE010)ST-C: INSTALLER & REMOVER (20099AE040) ...

Rear shock absorber
...

Other materials:

Operation
SECURITY AND LOCKS > Impact SensorOPERATION1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR1. Make an impact sensor setting.(1) Connect the Subaru Select Monitor.NOTE:For detailed operation procedures, refer to “Application help”.(2) Turn the ignition switch to ON.(3) On «Start» ...

Defogger and deicer
Rear window defogger Outside mirror defogger (if equipped) Windshield wiper deicer (if equipped) The vehicle is equipped with a rear window defogger. Some models are also equipped with an outside mirror defogger and/or windshield wiper deicer. The defogger and deicer system is acti ...

Rear window wiper and washer switch
Washer (accompanied by wiper operation) Continuous Intermittent Off Washer (accompanied by wiper operation) ...

© 2016-2024 Copyright www.sucross.com