Subaru Crosstrek Service Manual: Installation

CAUTION:

If the steering wheel and steering angle sensor are removed, perform the following VDC setting mode.

– Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

– Model with EyeSight: Neutral of Steering Angle Sensor & Lateral G Sensor 0 point setting VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

– Model with EyeSight: Longitudinal G sensor & lateral G sensor 0 point setting VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

1. Install the grommet to the toe board.

2. Insert the end of the column assembly - steering into the toe board grommet.

3. Tighten the column assembly - steering installation bolt located under the beam COMPL - steering with the tilt lever fixed.

Tightening torque:

20 N·m (2.04 kgf-m, 14.8 ft-lb)

4. Connect all connectors located under the beam COMPL - steering.

5. Install the airbag module. Driver’s Airbag Module > INSTALLATION">

6. Install the knee airbag module. Knee Airbag Module > INSTALLATION">

7. Install the cover assembly - instrument panel LWR driver INN and OUT.

8. Install the universal joint assembly - steering. Universal Joint > INSTALLATION">

CAUTION:

• Always install the universal joint assembly - steering after installing the steering column to avoid damage to the universal joint assembly - steering.

• Be sure to follow the tightening order and tightening torque of the universal joint assembly - steering to avoid the steering effort from becoming heavy.

9. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT">

10. Install the steering wheel. Steering Wheel > INSTALLATION">

Removal

Steering wheel

Other materials:

Inspection
CONTROL SYSTEMS > MT Gear Shift LeverINSPECTION1. Check the parts (bushing, cushion rubber, spacer, boot, stay and rod, etc.) for deformation, damage and wear. If necessary, correct or replace faulty parts. Compare the removed parts with new parts to judge if there are damages or not.(A)Bushing(B ...

Removal
EXTERIOR/INTERIOR TRIM > Upper Inner TrimREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing senso ...

Component
POWER ASSISTED SYSTEM (POWER STEERING) > General DescriptionCOMPONENT1. STEERING WHEEL AND COLUMN(1)Bushing(7)Cover - steering wheel LWR(13)Airbag module(2)Column ASSY - steering(8)MID switch (3)Switch ASSY - combination(9)Paddle shiftTightening torque: N·m (kgf-m, ft-lb)(4)Cover ASSY - c ...