Subaru Crosstrek Service Manual: Installation

1. Install each part in the reverse order of removal.

CAUTION:

• The front seat mounting bolts differ between the front mounting points and the rear mounting points. When installing the front seat, make sure that you are using correct bolts at correct positions.

• Tighten the slide rail assembly installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.

• Front (bolt A): Washer diameter 22 mm (0.87 in)

• Rear (bolt B): Washer diameter 26 mm (1.02 in)

Tightening torque:

Front seat assembly: 53 N·m (5.40 kgf-m, 39.1 ft-lb)

Tightening torque:

Lever assembly - hand brake: 18 N·m (1.84 kgf-m, 13.3 ft-lb)

Console box assembly: 6.5 N·m (0.66 kgf-m, 4.8 ft-lb)

2. Install a new adjusting nut (self-locking nut).

3. Be sure to adjust the lever stroke. Parking Brake Lever > ADJUSTMENT">

Inspection

Transmission gear oil

Other materials:

Inspection
LIGHTING SYSTEM > Rear Height SensorINSPECTION1. Connect three dry cell batteries (1.5 V) in series.NOTE:• Use new dry-cell batteries.• Using a circuit tester, check that the initial voltage of each dry-cell battery is 1.6 V or more. And also check that the voltage of three batteries ...

Dtc b1401 meter collation
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1401 METER COLLATIONDTC DETECTING CONDITION:Reference code incompatibility between combination meter and body integrated unitCAUTION:When the combination meter is replaced, registration of the immobilizer syst ...

Specification
FRONT SUSPENSION > General DescriptionSPECIFICATIONTire sizeP225/55R17225/55R17FrontWheel arch height452 (17.8)(Tolerance: +12 mm −24 mm (+0.47 in −0.94 in))mm (in)Camber (tolerance: ±0°45' Differences between RH and LH: 45' or less)0°10'Caster (referential valu ...