MECHANICAL(H4DO) > V-belt
INSTALLATION
1. V-BELT
Install in the reverse order of removal.
CAUTION:
• When reusing the V-belt, wipe off dust and water with cloth.
• Do not use the V-belt if there is any oil, grease or coolant on the belt.
• Be careful not to rub the V-belt end surface with bare hands; exposed core may cause injury.
• Wipe off any dust, oil and water on the groove of each pulley with cloth.
(A) | V-belt | (D) | V-belt tensioner ASSY | (G) | A/C compressor pulley |
(B) | Water pump pulley | (E) | Generator pulley | ||
(C) | Crank pulley | (F) | Idler pulley |
Tightening torque:
7 N·m (0.7 kgf-m, 5.2 ft-lb)
2. V-BELT TENSIONER ASSEMBLY AND IDLER PULLEY
1. Install the idler pulley to the chain cover.
NOTE:
When installing the idler pulley, be careful of the idler pulley cover direction.
(a) | Idler pulley cover | (b) | Protrusion (3 places) |
Tightening torque:
36 N·m (3.7 kgf-m, 26.6 ft-lb)
2. Install the V-belt tensioner assembly onto the generator bracket.
NOTE:
When installing the V-belt tensioner assembly, insert the protrusion of V-belt tensioner assembly into the hole for preventing rotation at the generator bracket.
(A) | V-belt tensioner ASSY | (C) | Hole to prevent rotation | (D) | Protrusion portion |
(B) | Generator bracket |
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
3. Install the cap to the V-belt tensioner assembly.
4. Install the V-belts.
Installation
IGNITION(H4DO) > Spark PlugINSTALLATION1. RH SIDEInstall in the reverse order of removal.CAUTION:Degrease the ignition coil installation portion and the mounting bolts.Tightening torque:Spark plug17.5 N·m (1.8 kgf-m, 12.9 ft-lb)Ignition coil8.5 N·m (0.9 kgf-m, 6.3 ft-lb)2. LH SIDEIn ...
Removal
SECURITY AND LOCKS > Front Hood Lock AssemblyREMOVAL1. Open the front hood.2. Remove the clip, and remove the bracket - grille.NOTE:To prevent damage to the bracket - grille, make sure to remove all clips.3. Remove the lock assembly - front hood.(1) Remove the bolt and clip.(2) Disconnect the rel ...
Dtc u0155 lost communication with instrument panel cluster (ipc) control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULEDetected when CAN data from combination meter does not arrive.NOTE:Perform the diagnosis for LAN syst ...