MECHANICAL(H4DO) > Camshaft
INSTALLATION
1. CAMSHAFT RH
The camshaft RH and cam carrier are designed as installing as a unit. Refer to “Cam Carrier” for installation procedures of camshaft RH. Cam Carrier > ASSEMBLY"> Cam Carrier > INSTALLATION">
2. CAMSHAFT LH
The camshaft LH and cam carrier are designed as installing as a unit. Refer to “Cam Carrier” for installation procedures of camshaft LH. Cam Carrier > ASSEMBLY"> Cam Carrier > INSTALLATION">
Switching power status
Operation indicator
Push-button ignition switch
The power status is switched every time
the push-button ignition switch is pressed.
1. Carry the access key, and sit in the
driver's seat.
2. Shift the select lever into the "P"
position.
3. Press the push-button ignition switch ...
Selecting audible signal operation (models without "keyless access with
push-button start system")
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Perform the following steps to deactivate
the audible signal. You can also use the
same steps to restore the function.
1. Sit in the drive ...
Dtc b2785 lin communication
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2785 LIN COMMUNICATIONDTC detecting condition:When the keyless access CM detected the collation system LIN bus communication error three times in a row.Trouble symptom:The keyl ...