Subaru Crosstrek Service Manual: Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Mounting System
INSTALLATION
1. PITCHING STOPPER
1. Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
2. Install the air intake boot. Air Intake Boot > INSTALLATION">
3. Connect the battery ground terminal.
2. CROSSMEMBER AND CUSHION RUBBER
1. Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
2. Install the transmission cushion rubber to the center crossmember, and temporarily tighten the nut (B).
Tightening torque:
Bolt (A)
35 N·m (3.6 kgf-m, 25.8 ft-lb)
3. Install the front crossmember and rear crossmember.
4. Tighten the transmission cushion rubber mounting nut.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103.3 ft-lb)
T3: 35 N·m (3.6 kgf-m, 25.8 ft-lb)
5. Remove the transmission jack.
6. Install the center exhaust cover.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
7. Install the center exhaust pipe. Center Exhaust Pipe > INSTALLATION">
8. Lower the vehicle.
9. Connect the battery ground terminal.
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Mounting SystemREMOVAL1. PITCHING STOPPER1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loos ...
General diagnostic table Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General Diagnostic TableINSPECTION1. MANUAL TRANSMISSIONSymptomsPossible causeCorrective action1. Gears are difficult to intermesh.NOTE:The cause for dif ...
Other materials:
Dtc c0036 rr pressure reducing valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0036 RR PRESSURE REDUCING VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble C ...
Dtc b2a02 tel2 antenna circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A02 TEL2 ANTENNA CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Any of the followings continues for 5 seconds or more.• TEL2 impedance is more than 1 M?. (Deta ...
General diagnostic table Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General Diagnostic TableINSPECTION1. MANUAL TRANSMISSIONSymptomsPossible causeCorrective action1. Gears are difficult to intermesh.NOTE:The cause for difficulty in shifting gears can be classified into two types: One is a defective gear shift system and ...
