MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven Gear
INSTALLATION
1. Install the taper roller bearing (transfer case side) outer race.
(A) | Taper roller bearing (transfer case side) outer race |
(B) | Transfer case |
2. Apply a coat of grease to the taper roller bearing (transfer case side) of transfer driven gear and the roller rolling surface of the taper roller bearing (extension case side).
Grease:
NICHIMOLY N-130 or equivalent
3. Install the transfer driven gear.
4. Select the adjusting washer. Transfer Case and Extension Case Assembly > INSTALLATION">
5. Install the transfer case and the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION">
6. Install the back-up light switch and the neutral position switch. Switches and Harness > INSTALLATION">
7. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION">
Caution
DRIVE SHAFT SYSTEM > General DescriptionCAUTION• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.• Remove contamination including dirt and corrosion before removal, installation, di ...
Vehicle capacity weight
Vehicle placard
The load capacity of your vehicle is
determined by weight, not by available
cargo space. The maximum load you can
carry in your vehicle is shown on the
vehicle placard attached to the driver's
side door pillar. It includes the total weight
of the driver and all passeng ...
Dtc b14a1 sunload sensor circuit low/open
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14A1 SUNLOAD SENSOR CIRCUIT LOW/OPENDTC detecting condition:Sunload sensor circuit is open. (Displayed for current malfunction)NOTE:When the sunload sensor check is performed indoors or in the shade ...