Subaru Crosstrek Service Manual: Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and Harness
INSTALLATION
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1. Install the back-up light switch & neutral position switch with the harness.
NOTE:
Use a new gasket.
Tightening torque:
32.3 N·m (3.3 kgf-m, 23.8 ft-lb)
(A) | Neutral position switch |
(B) | Back-up light switch |
2. Secure the harness on each clip.
3. Lower the vehicle.
4. Connect the connectors for back-up light switch and neutral position switch, and secure the connector to the bracket.
5. Install the air intake boot. Air Intake Boot > INSTALLATION">
6. Connect the battery ground terminal.
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessREMOVAL1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air in ...
Other materials:
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchADJUSTMENT1. Install the transfer clutch assembly to the extension case with the transfer driven gear shims and thrust bearings removed.2. Install the thrust bearing to the transfer driven gear.NOTE:Make sure to install in the right direc ...
Electrical component location Location
AIRBAG SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Front sub sensor (RH)(11)Side airbag sensor (RH)(20)Satellite safing sensor(2)Front sub sensor (LH)(12)Seat belt pretensioner (LH)(21)Occupant detection control module(3)Airbag control module(13)Seat belt pretensioner (RH)(22)B ...
Control screen and panel
Control screen (main screen and station screen)
Select to display the audio source
selection screen.
Select to open the station list. Refer to
"Using aha application"
Select to fast forward the current content
item by 30 seconds.
Select to display the contents list of the
selec ...
