Subaru Crosstrek Service Manual: Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft Assembly
INSTALLATION
1. Attach the needle bearing and oil seal to the front of the main shaft assembly.
NOTE:
• Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.
• Apply NICHIMOLY N-130 or the equivalent to the sealing lip of the oil seal.
• Use a new oil seal.
2. Fit the knock pin hole of the needle bearing outer race to the transmission case knock pin, and install the main shaft assembly.
NOTE:
• Align the end face of the seal with surface (A) when installing the oil seal.
• Face the cutout portion of the snap ring for the ball bearing to the drive pinion shaft assembly.
3. Install the drive pinion shaft assembly. Drive Pinion Shaft Assembly > INSTALLATION">
4. Check each shifter fork. Shifter Fork and Rod > INSPECTION">
5. Select a main shaft rear plate. Main Shaft Assembly > ADJUSTMENT">
6. Install the transmission case. Transmission Case > INSTALLATION">
7. Install the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION">
8. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION">
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSPECTIONDisassembled parts should be washed with cleaning solvent first, then inspected carefully.1. BearingReplace the bearings in ...
Other materials:
Dtc u0101 lost communication with tcm
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMNOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunction of CAN communication.Judge as NG when CA ...
Operation
HI - Rapid heating
LO - Normal heating
Off
Left-hand side
Right-hand side
To turn on the seat heater, push the "LO"
or "HI" position on the switch, as desired,
depending on the temperature.
Selecting the "HI" position will cause the
seat to heat up quicker.
To turn off ...
Location
CONTROL SYSTEMS > AT Shift Lock Control SystemLOCATION1. MODEL WITHOUT PUSH BUTTON IGNITION SWITCH(1)TCM (“P” range)(4)Key cylinder (with built-in key warning switch)(6)“P” range switch(2)Body integrated unit(5)Solenoid unit(7)Key lock solenoid(3)Stop light and brake switc ...
