LUBRICATION(H4DO) > Oil Pressure Switch
INSTALLATION
1. Apply liquid gasket to the oil pressure switch threads.
Liquid gasket:
THREE BOND 1324 (Part No. 004403042) or equivalent
2. Install the oil pressure switch to the chain cover.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
3. Connect the terminal to the oil pressure switch.
NOTE:
The oil pressure switch harness must be tightened within the range of a 90° angle as shown below.
Tightening torque:
1.5 N·m (0.2 kgf-m, 1.1 ft-lb)
(A) | Upper side of the engine |
4. Attach the rubber cap.
5. Connect the battery ground terminal. NOTE">
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3 ...
Front seats
WARNING
Never adjust the seat while driving
to avoid loss of vehicle control
and personal injury.
Before adjusting the seat, make
sure the hands and feet of rear
seat passengers and cargo are
clear of the adjusting mechanism.
After adjusting the seat, push it
slightly to make sur ...
Installing a booster seat
WARNING
Child restraint systems and seatbelts
can become hot in a vehicle
that has been closed up in sunny
weather; they could burn a small
child. Check the child restraint
system before you place a child
in it.
Do not leave an unsecured child
restraint system in your vehicle.
...