Subaru Crosstrek Service Manual: Installation
LUBRICATION(H4DO) > Engine Oil Filter
INSTALLATION
1. OIL FILTER
CAUTION:
Do not tighten excessively, or oil may leak.
1. Clean the oil filter installation surface.
2. Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.
3. Install the oil filter by turning it by hand, being careful not to damage the seal rubber of the oil filter.
• Tighten the oil filter (black) with an outer diameter of 68 mm (2.68 in) (approx. 1 rotation) after the seal rubber of the oil filter comes in contact with chain cover. When using a torque wrench, tighten to 14 N·m (1.4 kgf-m, 10.3 ft-lb).
• Tighten the oil filter (blue) with an outer diameter of 67.4 mm (2.65 in) (approx. 7/8 rotation) after the seal rubber of the oil filter comes in contact with chain cover. When using a torque wrench, tighten to 12 N·m (1.2 kgf-m, 8.9 ft-lb).
4. After installing, check the engine oil level and replenish it if necessary. Engine Oil > INSPECTION">
2. OIL PUMP UNION
Install in the reverse order of removal.
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
Removal
LUBRICATION(H4DO) > Engine Oil FilterREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. OIL FILTER1. ...
Other materials:
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Mix Door ActuatorINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the ...
Dtc c0056 g sensor abnormal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0056 G SENSOR ABNORMALDTC DETECTING CONDITION:Longitudinal G sensor signal failureTROUBLE SYMPTOM:• ABS does not operate.• VDC does not operate.• EyeSight does not operate. ...
Inspection
SECURITY AND LOCKS > Door Lock Control SystemINSPECTION1. SYMPTOM CHARTSymptomsRepair orderReferenceThe door lock control system does not operate.1. Remove and visually inspect the following fuses.• No. 3 (in fuse & relay box)• No. 7 (in fuse & relay box)• No. 8 (in main ...
