Subaru Crosstrek Service Manual: Installation
LIGHTING SYSTEM > Rear Height Sensor
INSTALLATION
1. Install each part in the reverse order of removal.
Tightening torque:
Sensor assembly - headlight beam leveler: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Rear wheel: Except for C4 model
120 N·m (12.24 kgf-m, 88.5 ft-lb)
Rear wheel: C4 model
100 N·m (10.20 kgf-m, 73.8 ft-lb)
2. Perform reinitialization of the sensor assembly - headlight beam leveler. Auto Headlight Beam Leveler System > PROCEDURE">
NOTE:
When replacing the sensor assembly - headlight beam leveler with a new part, perform the initialization. Auto Headlight Beam Leveler System > PROCEDURE">
Removal
LIGHTING SYSTEM > Rear Height SensorREMOVALCAUTION:Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.1. Disconnect the ground cable from ...
Other materials:
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorINSTALLATIONCAUTION:Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.Install in the reverse order of removal.NOTE:• Use new O-rings.&bul ...
Pretensioner connector Procedure
SEAT BELT SYSTEM > Pretensioner ConnectorPROCEDUREFor connectors of seat belt pretensioner, lap seat belt pretensioner and buckle switch RH, refer to “Airbag Connector” of “AIRBAG SYSTEM” section or “OCCUPANT DETECTION SYSTEM” section.• Airbag system: Ai ...
Dtc p0500 vehicle speed sensor "a" circuit
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0500 VEHICLE SPEED SENSOR "A" CIRCUITDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:VDC does not operate.STEPCHECKYESNO1.CHECK DTC.Read the DTC of VDC ...
