Subaru Crosstrek Service Manual: Installation
LIGHTING SYSTEM > Headlight Bulb
INSTALLATION
CAUTION:
Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).
1. Install each part in the reverse order of removal.
2. When performing the work of HID type low beam RH, secure the flange section of the bumper face - front to the bracket - front bumper side.
3. When performing the work of HID type low beam RH, adjust the fog light beam. Front Fog Light Assembly > ADJUSTMENT">
Removal
LIGHTING SYSTEM > Headlight BulbREMOVAL1. HIGH BEAMCAUTION:• Do not perform work with wet hands, because there is a possibility of electrical shock.• Do not leave the light assembly - h ...
Headlight system
...
Other materials:
Dtc p2750 intermediate shaft speed sensor "c" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2750 INTERMEDIATE SHAFT SPEED SENSOR "C" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Shifting shock is felt.• ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Sub Level SensorINSPECTION1. Check that the fuel sub level sensor has no damage.2. Measure the fuel sub level sensor float position.(1)FULL(2)EMPTY(3)Datum pointsFloat positionStandardFULL to Datum point (A)5.31±3.5 mm (0.209±0.138 in)EMPTY to Datum po ...
Dtc p0851 park/neutral switch input circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0851 PARK/NEUTRAL SWITCH INPUT CIRCUIT LOW1. AT MODELDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing or replacing f ...
