Subaru Crosstrek Service Manual: Installation
LIGHTING SYSTEM > Day Time Running Resistor
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Resistor assembly - daytime running light: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Removal
LIGHTING SYSTEM > Day Time Running ResistorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of t ...
Door switch
...
Other materials:
System servicing
WARNING
When discarding a seatbelt retractor
assembly or scrapping
the entire vehicle damaged by a
collision, consult your SUBARU
dealer.
Tampering with or disconnecting
the system's wiring could result
in accidental activation of the
seatbelt pretensioner and/or
SRS airbag or ...
ABS warning light
CAUTION
If any of the following conditions
occur, we recommend that you
have the ABS repaired at the first
available opportunity by your
SUBARU dealer.
The warning light does not
illuminate when the ignition
switch is turned to the "ON"
position.
The warning light illuminates
wh ...
Removal
COMMUNICATION SYSTEM > HornREMOVALCAUTION:Do not remove the bumper face - front when removing the horn, in order to prevent damaging the claws of the bracket - front bumper corner and the bracket - front bumper side.1. Disconnect the ground cable from battery. NOTE">2. Remove the clip, a ...
