Subaru Crosstrek Service Manual: Installation

1. Install the bolt (A) and nut (B) which secure the air cleaner case (front) to the body.

Tightening torque:

Bolt (A)

6 N·m (0.6 kgf-m, 4.4 ft-lb)

Nut (B)

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Install the air cleaner case (rear) and air cleaner element.

NOTE:

• Check that there is no dirt or dust within the air cleaner case. If any dirt or dust is found, clean it.

• Install the air cleaner element as shown in the figure.

3. Install the clips (B) to the air cleaner case (front), then tighten the clamp (A) that secures the air intake boot to the air cleaner case (rear).

Tightening torque:

Clamp (A)

3 N·m (0.3 kgf-m, 2.2 ft-lb)

4. Connect the connector (A) to the mass air flow and intake air temperature sensor and secure the harness with clip (B).

5. Install the air intake duct. Air Intake Duct > INSTALLATION">

6. Connect the battery ground terminal. NOTE">

Removal

Air cleaner element

Other materials:

Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR CoolerINSTALLATION1. Set the gasket to the stud bolt.NOTE:Use a new gasket.2. Temporarily tighten the bolts securing the EGR cooler to the EGR control valve and the cylinder head RH, and tighten in numerical order.NOTE:Use a new gasket. ...

Inspection mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Inspection ModeOPERATIONIt is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is r ...

After driving
Always check your brakes for effectiveness immediately after driving in sand, mud or water. Do this by driving slowly and stepping on the brake pedal. Repeat that process several times to dry out the brake discs and brake pads. After driving through tall grass, mud, rocks, sand, riv ...