INSTRUMENTATION/DRIVER INFO > Combination Meter
INSTALLATION
CAUTION:
• Make sure the electrical connector is connected securely.
• Make sure that each meter operates normally.
• When the combination meter assembly has been replaced, be sure to perform the following operations.
– For models without the keyless access with push button start except for C5, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MANUAL FOR IMMOBILIZER”.
– Be sure to reset the ODO fuel economy value of the multi-function display (MFD). (High grade type) Multi-function Display (MFD) System > OPERATION">
Install each part in the reverse order of removal.
Auto light sensor sensitivity setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Auto Light Sensor" item. Then
push the button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Selec ...
Using a flat-bed truck
This is the best way to transport your
vehicle. Use the following procedures to
ensure safe transportation.
1. Shift the select lever into the "P" position for CVT models. Shift the shift
lever into the "1st" position for MT models.
2. Pull up the parking brake lever firmly.
3. Secur ...
Component
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General DescriptionCOMPONENT1. TRANSMISSION CASE(1)Transmission case ASSY(7)Pitching stopper bracketTightening torque: N·m (kgf-m, ft-lb)(2)Gasket(8)Oil level gaugeT:44 (4.5, 32.5) (aluminum gasket, silver)(3)Drain plug(9)Harness clip 70 (7.1, 51 ...