Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Hose and Pipe

INSTALLATION

CAUTION:

If the hose and pipe have been replaced, add an appropriate amount of compressor oil to the compressor. Compressor Oil > ADJUSTMENT">

Replace the O-rings with new parts, and then apply compressor oil.

When connecting hoses and pipes, do not apply excessive force. After installing, check that no torsion or excessive tension applied to the hoses.

1. Install each part in the reverse order of removal.

Tightening torque:

Air conditioning unit: General Description > COMPONENT">

2. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">

Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Hose and PipeREMOVAL1. LOW-PRESSURE HOSE1. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE&qu ...

In-vehicle sensor (auto a/c model)
...

Other materials:

Tire inspection
Check on a daily basis that the tires are free from serious damage, nails, and stones. At the same time, check the tires for abnormal wear. Contact your SUBARU dealer immediately if you find any problem. NOTE When the wheels and tires strike curbs or are subjected to harsh treatment as wh ...

Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Control PanelINSPECTION1. CHECK ILLUMINATION1. Check the illumination operation when battery voltage is applied between the terminals of control panel.• Manual A/C modelTerminal No.Inspection conditionsSpecificationConnection diagram14 (+) — 12 ( ...

Dtc b2304 rear radar on-off switch stuck
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2304 REAR RADAR ON-OFF SWITCH STUCKDTC detecting condition:• BSD/RCTA OFF switch is stuck to ON. (Switch malfunction)• Switch was left pressed for a prolonged time ...

© 2016-2024 Copyright www.sucross.com