HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator Sensor
INSTALLATION
CAUTION:
• Make sure that the water seal packing on the cover attachment area is securely attached.
• Replace the O-rings with new parts, and then apply compressor oil.
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Install the thermostat - cooling at the position shown in the figure below.
(1) | Evaporator ASSY - cooling | (3) | Thermostat - cooling | (5) | Fifth row fin from the left end |
(2) | Center | (4) | 130 mm (5.12 in) from the upper end of the fins |
2. Install each part in the reverse order of removal.
3. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">
Dtc b1900 short in front p/t rh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1900 SHORT IN FRONT P/T RHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (RH) circuit is shorted.• Pretensioner (RH) is faulty.• Pretensioner harness ...
Dtc b1628 side airbag sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1628 SIDE AIRBAG SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (LH) an ...
Dtc b1908 short in front p/t lh (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1908 SHORT IN FRONT P/T LH (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (LH) circuit is shorted to power supply.• Pretensioner (LH) is faulty.&bul ...