Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator

INSTALLATION

CAUTION:

If the evaporator assembly - cooling has been replaced, add an appropriate amount of compressor oil. Compressor Oil > ADJUSTMENT">

When the evaporator assembly - cooling has been replaced, replace the packing of the expansion valve - cooling with a new one, and then apply compressor oil.

Make sure that the water seal packing on the cover attachment area is securely attached.

Replace the O-rings with new parts, and then apply compressor oil.

After installing the grille assembly - ventilation RH, check that the air vent grille of the grille assembly - ventilation RH is inserted correctly into the air vent duct.

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Install the thermostat - cooling to the specified position. Evaporator Sensor > INSTALLATION">

2. Install each part in the reverse order of removal.

Tightening torque:

Heater and cooling unit: General Description > COMPONENT">

3. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">

Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > EvaporatorREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBA ...

Evaporator sensor
...

Other materials:

Removal
LIGHTING SYSTEM > Combination Switch (Light)REMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Set the tire to the straight-ahead position.2. ...

Component
BRAKE > General DescriptionCOMPONENT1. FRONT DISC BRAKE(A)Shim-separate brake pad type(B)Shim-integrated brake pad type (1)Caliper body(11)Pad clip - upper(19)Cap - bleeder(2)Bleeder - screw(12)Pad clip - lower (3)Guide pin - front brake (black)(13)Shim - disc brake front*1:17 mm (width a ...

Parking brake stroke
Check the parking brake stroke according to the maintenance schedule in the "Warranty and Maintenance Booklet". When the parking brake is properly adjusted, braking power is fully applied by pulling the lever up 7 to 8 notches gently but firmly (approximately 45 lbf [200 N, 20.4 kgf]). ...

© 2016-2024 Copyright www.sucross.com