HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor
INSTALLATION
CAUTION:
• Replace the O-rings on the hose - pressure suction and discharge with new parts, and then apply compressor oil.
• After replacing the compressor assembly, adjust the amount of the compressor oil. Compressor Oil > ADJUSTMENT">
1. Install each part in the reverse order of removal.
Tightening torque:
Air conditioning unit: General Description > COMPONENT">
Compressor: General Description > COMPONENT">
V-belt cover bracket and generator bracket: General Description > COMPONENT">
2. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Case and Extension Case AssemblyASSEMBLY1. EXTENSION CASE1. Using the ST, install the oil seal to the extension case. Oil Seal">NOTE:Use a new oil seal.2. Install the dust cover.3. Install the shift bracket.Tightening torque:24.5 N&mid ...
Dtc b11f7 side impact deployment
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11F7 SIDE IMPACT DEPLOYMENTDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:This DTC is displayed when the side airbag module and curtain airbag module are deployed.Once this DTC is displayed, t ...
Removal
SECURITY AND LOCKS > Rear Outer HandleREMOVAL1. Raise the glass assembly - rear door to the top position.2. Disconnect the ground cable from battery. NOTE">3. Remove the trim panel - rear door. Door Trim > REMOVAL">4. Remove the sealing cover - rear door. Rear Sealing Cover ...