FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Rear Oxygen Sensor
INSTALLATION
CAUTION:
If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.
1. Before installing rear oxygen sensor, apply the anti-seize compound only to the threaded portion of rear oxygen sensor to make the next removal easier.
CAUTION:
Never apply anti-seize compound to the protector of rear oxygen sensor.
Anti-seize compound:
NEVER-SEEZ NSN, JET LUBE SS-30 or equivalent
2. Install the rear oxygen sensor.
Tightening torque:
21 N·m (2.1 kgf-m, 15.5 ft-lb)
3. Connect the rear oxygen sensor connector.
NOTE:
Be careful not to allow the rear oxygen sensor harness to interfere with the sensor unit and the front oxygen (A/F) sensor harness.
(A) | Front oxygen (A/F) sensor connector | (B) | Rear oxygen sensor connector | (C) | Clip |
4. Install the under cover. Front Under Cover > INSTALLATION">
5. Lower the vehicle.
6. Connect the battery ground terminal.
Inspection
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostics with PhenomenonINSPECTION(1) Perform the diagnosis according to the diagnostic procedure of the corresponding symptom that is shown in the symptom list.(2) If there are multiple symptoms, perform the diagnosis in the symptom sequence (1 > 2 &g ...
Drive cycle Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Drive CyclePROCEDUREIt is necessary to perform the drive cycle listed below if DTC is not found in the Inspection Mode. It is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cyc ...
Specification
DRIVE SHAFT SYSTEM > General DescriptionSPECIFICATION1. PROPELLER SHAFTPropeller shaft typeEDJFront propeller shaft joint-to-joint length: L1CVT675.5 mm (26.59 in)MT735.5 mm (28.96 in)Rear propeller shaft joint-to-joint length: L2723 mm (28.46 in)Outer diameter of tube:D163.5 mm (2.50 in)D257.5 m ...