FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Injector
INSTALLATION
Install in the reverse order of removal.
NOTE:
• Use new fuel injector holder, O-rings, rubbers and seal rings.
• Install the fuel injector so that the connector joint faces the connector rotation stopper side of the fuel pipe.
• Securely put the flange section of fuel pipe into the groove of fuel injector holder.
(a) | Fuel injector | (b) | Connector joint | (c) | Fuel pipe |
(d) | Connector rotation stopper | (e) | Flange section | (f) | Fuel injector holder |
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
Removal
COOLING(H4DO) > RadiatorREMOVALCAUTION:The radiator is pressurized when the engine and radiator are hot. Wait until engine and radiator cool down before working on the radiator.1. Disconnect the ground cable from battery. NOTE">2. Remove the V-belt covers.3. Remove the grille bracket.NOT ...
Preparation tool
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Mon ...
Installation
BRAKE > Stop Light SwitchINSTALLATION1. BULB TYPE1. Install the stop light switch.CAUTION:• Turn the stop light switch clockwise when installing so that it can return backward by approximately 1 mm (0.04 in) and clearance is automatically adjusted.• If it is hard to turn the switch, r ...