Subaru Crosstrek Service Manual: Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Filter
INSTALLATION
1. Install O-ring (A), O-ring (B), and backup ring (C) to the pressure regulator.
NOTE:
• Use new O-rings.
• Apply gasoline to the O-ring and backup ring.
2. Install the pressure regulator to the fuel filter assembly.
3. Install O-ring (A), spacer (B), and connector cable (C) to the fuel pump.
NOTE:
• Use new O-rings and the connector cable.
• Apply gasoline to the O-rings and the spacer.
4. Install the fuel pump to the fuel filter assembly.
NOTE:
After installation, make sure five claws are correctly engaged in each position.
5. Check that the cushions of the fuel chamber assembly for dislocation. If any of them is dislocated, install a new cushion.
6. Slowly press in and install the tube assembly to the fuel chamber assembly until a clicking sound is heard.
7. Connect the tube assembly to the fuel chamber assembly.
8. Install the fuel filter assembly to the fuel chamber assembly.
NOTE:
• Set the tube (A) and spring (B) for the fuel filter assembly as shown in the figure.
• Check that the claw connecting the fuel camber assembly and the fuel filter assembly is securely fastened.
9. Push the fuel filter assembly in the direction of the arrow to compress, and attach the clip.
NOTE:
Use a new clip.
10. Secure the connector cable with the clip, and connect the connector (A) of the connector cable.
11. Install the fuel level sensor. Fuel Level Sensor > INSTALLATION">
12. Inspect the fuel level sensor. Fuel Level Sensor > INSPECTION">
13. Install the fuel pump assembly. Fuel Pump > INSTALLATION">
Fuel filter
...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel FilterREMOVALWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:• Be careful not to spill fuel.• If the fuel gauge ...
Other materials:
Read cancel code Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Read Cancel CodeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, sele ...
Removal
SECURITY AND LOCKS > Body Integrated UnitREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Ambient SensorREMOVAL1. Disconnect the ground cable from battery. Battery > REMOVAL">2. Remove the ambient sensor.(1) Disconnect the connector.(2) Release the claws, and then remove the ambient sensor from the bracket. ...
