Subaru Crosstrek Service Manual: Installation

1. Open the fuel filler lid.

2. Insert the fuel filler pipe assembly into the rubber saucer from inside of the rear fender.

3. Install the fuel filler pipe assembly to the vehicle.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

4. Securely insert the fuel filler hose (A) and evaporation hose (B) until the hose end contacts the spool, then attach the clamp or clip as shown in the figure.

Tightening torque:

2.5 N·m (0.3 kgf-m, 1.8 ft-lb)

5. Install the rear mud guard RH. Mud Guard > INSTALLATION">

6. Install the rear sub frame assembly. Rear Sub Frame > INSTALLATION">

7. Connect the battery ground terminal.

8. Inspect the wheel alignment and adjust if necessary.

9. Perform reinitialization of the auto headlight beam leveler system. (Model with auto headlight beam leveler) Auto Headlight Beam Leveler System > PROCEDURE">

10. Adjust the steering angle sensor. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

Removal

Fuel filter

Other materials:

Removal
EXTERIOR BODY PANELS > Front FenderREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the bumper face - front. Front Bumper > REMOVAL">3. Remove the light assembly - head. Headlight Assembly > REMOVAL">4. Remove the cover - front fender.(1) Remove ...

Inspection
LIGHTING SYSTEM > Day Time Running Light SystemINSPECTION1. DAYTIME RUNNING LIGHT SYSTEM CHECKSTEPCHECKYESNO1.CHECK FUSE.1) Turn the ignition switch to OFF.2) Check the headlight HI fuse.Is the fuse OK? Day Time Running Light System > INSPECTION">Go to Step 2.Replace the fuse.2.CHECK R ...

Dtc u0401 invalid data received from ecm/pcm a
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”Detected when there is malfunction in CAN data from the engine control module (ECM).NOTE:Perform the diagnosis for LAN system. Basic Diagnosti ...