Subaru Crosstrek Service Manual: Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Delivery and Evaporation Lines
INSTALLATION
Install in the reverse order of removal while being careful of the following.
NOTE:
When connecting the fuel delivery tube (a) and evaporation hose (b), let the bushing (c) contact the quick connector (d) of fuel delivery tube to prevent the clip (e) from contacting the quick connector (d).
1. CONNECTING THE EVAPORATION LINE QUICK CONNECTOR
Connect the quick connector as shown in the figure.
CAUTION:
• Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.
• Make sure that the quick connector is securely connected.
2. CONNECTING THE FUEL LINE QUICK CONNECTOR
Connect the quick connector as shown in the figure.
CAUTION:
• Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.
• When connecting the quick connector, make sure to insert it all the way in before locking the slider.
• When it is difficult to lock the slider, check that the connector is fully inserted.
• After locking the slider, check again that the quick connector is securely connected.
(a) | Slider |
3. EVAPORATION HOSE CONNECTION
Connect the evaporation hose by inserting it to the pipe until the hose reaches the spool or bump.
(a) | Hose | (c) | Spool or bump | (d) | Pipe |
(b) | Clip |
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Delivery and Evaporation LinesREMOVALWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:Be careful not to spill fuel.1. Releas ...
Fuel filler pipe
...
Other materials:
Headlights (models without HID headlights)
CAUTION
Halogen headlight bulbs become
very hot while in use. If you touch
the bulb surface with bare hands or
greasy gloves, fingerprints or
grease on the bulb surface will
develop into hot spots, causing the
bulb to break. If there are finger
prints or grease on the bulb surface,
wipe the ...
Removal
CLUTCH SYSTEM > Master CylinderREMOVALCAUTION:• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.• Before handling the airbag system components, refer to “CAUTIO ...
Preparation tool
INSTRUMENTATION/DRIVER INFO > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer ...
