FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) Sensor
INSTALLATION
CAUTION:
If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.
1. Before installing front oxygen (A/F) sensor, apply anti-seize compound only to the threaded portion of front oxygen (A/F) sensor to make the next removal easier.
CAUTION:
Never apply anti-seize compound to the protector of front oxygen (A/F) sensor.
Anti-seize compound:
NEVER-SEEZ NSN, JET LUBE SS-30 or equivalent
2. Install the front oxygen (A/F) sensor.
Tightening torque:
21 N·m (2.1 kgf-m, 15.5 ft-lb)
3. Lift up the vehicle.
4. Connect the front oxygen (A/F) sensor connector, and secure the front oxygen (A/F) sensor harness by using the clip.
(A) | Front oxygen (A/F) sensor connector | (B) | Rear oxygen sensor connector | (C) | Clip |
5. Install the under cover. Front Under Cover > INSTALLATION">
6. Lower the vehicle.
7. Install the radiator sub fan and fan motor assembly. Radiator Sub Fan and Fan Motor > INSTALLATION">
8. Connect the battery ground terminal.
Automatic headlight beam leveler warning light (models with HID headlights)
This
light illuminates when the automatic
headlight beam leveler does not operate
normally.
If this light illuminates while driving or does
not turn off approximately 3 seconds after
turning the ignition switch to the "ON"
position, have your vehicle inspected at
your SUBARU dealer.
Fr ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Filler PipeINSTALLATION1. Open the fuel filler lid.2. Insert the fuel filler pipe assembly into the rubber saucer from inside of the rear fender.3. Install the fuel filler pipe assembly to the vehicle.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-l ...
Operation
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD) SystemOPERATION1. DIAGNOSTIC MODE (HIGH GRADE TYPE ONLY)The settings of the multi-function display can be changed by performing the following procedures to display the diagnostic mode. To show the demonstration display only, refer to &ldq ...