Subaru Crosstrek Service Manual: Installation

Subaru Crosstrek Service Manual / Fuel injection (fuel systems)(h4do) / Engine control module (ecm) / Installation

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Control Module (ECM)

INSTALLATION

Install in the reverse order of removal.

CAUTION:

• When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system.

• For model without keyless access with push button start, refer to the Type B in “REGISTRATION MANUAL FOR IMMOBILIZER”.

• For model with keyless access with push button start, refer to the Type D in “REGISTRATION MANUAL FOR IMMOBILIZER”.

• If replacing ECM or the bracket, replace both parts with new parts at a time.

• After installing the bracket to ECM, do not separate the bracket.

• If the bracket has been installed to ECM in the wrong direction, replace both parts to new parts.

NOTE:

When replacing the ECM, be careful not to use the ECM of wrong specification to avoid any damage on the fuel injection system.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

Removal

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Control Module (ECM)REMOVAL1. Disconnect the ground cable from battery.2. Remove the glove box. Glove Box > REMOVAL">3. Disconnect the conne ...

Engine coolant temperature sensor

...

Other materials:

Operation
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. READ CURRENT DATA1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, ...

Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control DeviceREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the inhibitor switch. Inhibitor Switch > REMOVAL">3. Remove the oil pan and oil strainer ...