FRONT SUSPENSION > Front Stabilizer
INSTALLATION
1. Before installation, inspect the following items and replace any faulty part with a new one.
• Check the bushing - stabilizer for abnormal cracks, fatigue or damage.
• Check the stabilizer link for damage.
2. Install each part in the reverse order of removal.
CAUTION:
• Install the clamp - stabilizer bushing with the arrow mark facing the front of the vehicle.
• Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).
Tightening torque:
Clamp - stabilizer: 25 N·m (2.55 kgf-m, 18.4 ft-lb)
Stabilizer link: 60 N·m (6.12 kgf-m, 44.3 ft-lb)
Support plate - crossmember: 60 N·m (6.12 kgf-m, 44.3 ft-lb)
Under cover - front: 18 N·m (1.84 kgf-m, 13.3 ft-lb)
3. Install the front wheels.
Tightening torque:
Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb)
C4 model: 100 N·m (10.20 kgf-m, 73.8 ft-lb)
Dtc p0961 pressure control solenoid "a" control circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0961 PRESSURE CONTROL SOLENOID "A" CONTROL CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Acceleration is poor during ...
Removal
SECURITY AND LOCKS > Keyless Access Indoor AntennaREMOVAL1. FRONT ANTENNA1. Disconnect the ground cable from battery. NOTE">2. Remove the cover - shift lever. Console Box > REMOVAL">3. Disconnect the connector and remove the front antenna assembly - interior.2. REAR ANTENNA1. ...
Inspection
COOLING(H4DO) > Radiator Fan SystemINSPECTIONOperating condition:Vehicle speedA/C compressor loadEngine coolant temperatureIncrease: 98°C (208°F) or lessDecrease: 96°C (205°F) or lessIncrease: 99 — 101°C (210 — 214°F)Decrease: ...