FRONT SUSPENSION > Front Crossmember Support Plate
INSTALLATION
CAUTION:
Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).
Install each part in the reverse order of removal.
Tightening torque:
Front crossmember support: 60 N·m (6.12 kgf-m, 44.3 ft-lb)
Under cover - front: 18 N·m (1.84 kgf-m, 13.3 ft-lb)
Removal
STARTING/CHARGING SYSTEMS(H4DO) > StarterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) securing the air cleaner case (rear) to the air intake boot.4. Loosen the clamp (C) which secures the throttle body t ...
Inspection
SECURITY AND LOCKS > Access KeyINSPECTION1. ACCESS KEY BATTERYCheck the access key battery voltage.Preparation tool:Circuit testerNOTE:Complete the measurement within 5 seconds because the battery discharges during measurement.Battery terminalInspection conditionsStandard(+) — (−)Connect ...
Average fuel consumption
U.S.-spec. models
Except U.S.-spec. models
This display shows the average rate of
fuel consumption since the trip meter was
last reset.
Trip knob
Pressing the trip knob toggles the display
between the average fuel consumption
corresponding to the A trip meter display
and ...