Subaru Crosstrek Service Manual: Installation

CAUTION:

• When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off.

• Do not reuse the tether clip removed from the upper part of the trim panel - front pillar UPR. Always replace with a new part.

• Do not reuse the upper clips of the trim panel - center pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.

• Before installing the trim panel - front pillar UPR, check the condition of protective non-woven fabric (white) of the curtain airbag. If it is damaged (airbag module cloth is exposed), replace the curtain airbag module assembly with a new part.

1. Remove the remaining tether clips from the vehicle body.

2. Install the trim panel - front pillar UPR.

(1) Check the installation status of the tether clips and install the trim panel - front pillar UPR.

3. Install each part in the reverse order of removal.

Tightening torque

Front seat belt: General Description > COMPONENT">

Trim panel - center pillar UPR: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Upper inner trim

Removal

Other materials:

Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearINSPECTION1. Taper roller bearingReplace the bearings in the following cases.• In case of broken or rusty bearings• In case of worn or damaged bearings• When the bearings fail to turn smoothly or emit noise in rotat ...

Airbag warning light illumination pattern Inspection
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Warning Light Illumination PatternINSPECTIONTurn the ignition switch to ON, and confirm that the airbag warning light remains on for approx. 6 seconds then turns off afterwards.(1)Airbag warning light(2)Approx. 6 seconds(3)Ignition switch ON ...

Adjustment
CLUTCH SYSTEM > Clutch PedalADJUSTMENT1. Turn the lock nut until the full stroke of clutch pedal becomes within the specification.CAUTION:When adjusting the full stroke of clutch pedal, do not turn the clutch switch.NOTE:If the lock nut cannot adjust the full stroke of clutch pedal to the specifi ...