EXTERIOR/INTERIOR TRIM > Side Garnish
INSTALLATION
CAUTION:
Do not reuse the garnish assembly. Deformation occurs on the garnish assembly when once removed, and this may cause improper adhesion.
1. Install each part in the reverse order of removal.
2. Install the garnish assembly - fender and the garnish assembly - rear quarter.
(1) Remove the double-sided tape remaining on the vehicle body, then clean the adhesive surface.
CAUTION:
If even a slight amount of double-sided tape remains on the adhesive surface, it may lead to improper adhesion.
(2) Heat the vehicle body and the garnish for 1 — 3 minutes using a heat light or a drier.
CAUTION:
Be careful not to burn yourself.
(3) Apply primer to the installation surfaces of garnish, and wait till the primer dries.
(4) Attach new double-sided tape on garnish.
(5) Peel off the backing papers, engage the clips, and adhere the garnish assembly to the vehicle body.
CAUTION:
Press-fit the garnish assembly to adhere securely.
Inspection
CONTROL SYSTEMS > AT Shift Lock Control SystemINSPECTION1. SHIFT LOCK OPERATION• Model without push button ignition switchSTEPCHECKYESNO1.CHECK COMMUNICATION OF SUBARU SELECT MONITOR.1) Turn the ignition switch to ON.2) Using the Subaru Select Monitor, check whether communication to all sys ...
Dtc p0751 shift solenoid "a" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0751 SHIFT SOLENOID "A" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Shift control malfunc ...
Dtc p0030 a/f / o2 heater control circuit bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0030 A/F / O2 HEATER CONTROL CIRCUIT BANK 1 SENSOR 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memor ...