EXTERIOR/INTERIOR TRIM > Roof Molding
INSTALLATION
1. Remove the clips from the molding - roof, and attach to the studs on the vehicle.
CAUTION:
• Always replace the clips that were damaged during removal of the molding - roof with new parts.
• While installing the molding - roof, be careful not to catch the glass molding with the tip of the front side and rear side.
2. Push the front end of the molding - roof against the front window, and attach the forward positioning clip onto the rivet on the body.
(1) | Windshield |
(2) | Positioning clip |
(3) | Molding - roof |
(4) | Rivet |
(5) | Clip |
3. While pushing down the molding - roof from above, connect the molding - roof and the clip.
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorINSTALLATIONCAUTION:If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Before installing front oxygen (A/F) sensor, apply anti-seize compound only to the threaded portio ...
Dtc p0328 knock/combustion vibration sensor 1 circuit high bank 1 or single sensor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0328 KNOCK/COMBUSTION VIBRATION SENSOR 1 CIRCUIT HIGH BANK 1 OR SINGLE SENSORDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Poor driving performance• Knocking occursCAUT ...
Dtc c2121 transmitter 1 no data
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2121 TRANSMITTER 1 NO DATANOTE:Refer to DTC C2124 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2124 TRANSMITTER 4 NO DATA"> ...