EXTERIOR/INTERIOR TRIM > Rear Gate Garnish
INSTALLATION
CAUTION:
Make sure that the harness grommet is securely installed.
If not properly installed, this may cause leaks.
Install each part in the reverse order of removal.
Tightening torque
Garnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb)
Motor assembly - rear wiper: 6 N·m (0.61 kgf-m, 4.4 ft-lb)
Arm assembly - rear wiper: 8 N·m (0.82 kgf-m, 5.9 ft-lb)
Removal
CONTROL SYSTEMS > AT Shift Lock Solenoid and “P” Range SwitchREMOVAL1. SOLENOID UNIT1. Remove the AT select lever. Select Lever > REMOVAL">2. Remove the spacer and gasket. Select Lever > DISASSEMBLY">3. Using a flat tip screwdriver with a thin tip, remove the h ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater DuctREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the battery ground cable ...
Coat hook
A coat hook is attached to the rear
passenger's hand grip.
WARNING
Obey the following instructions.
Do not hang coat hangers or
other hard or pointed objects on
the coat hooks. Hang clothing
directly on the coat hooks without
using hangers.
Before hanging clothing on the
coat ...