EXTERIOR/INTERIOR TRIM > Rear Bumper
INSTALLATION
Install each part in the reverse order of removal.
CAUTION:
Before installing the bumper face, match the claws on the bracket - rear bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, the flange section may be broken or the clearance between fender panel and bumper face may not be uniform.
NOTE:
If the bumper face - rear comes off too easily, adjust the hook of the bracket side.
Tightening torque:
Rear bumper component: General Description > COMPONENT">
Light assembly - rear combination: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Fuel filler lid and cap
Locations of the fuel filler lid and
the lid release lever
Fuel filler lid
Fuel filler lid release lever
Refueling
Only one person should be involved in
refueling. Do not allow others to approach
the area of the vehicle near the fuel filler
pipe while refueling is in progress.
Be ...
Dtc b27a8 trunk/rear gate external antenna open
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B27A8 TRUNK/REAR GATE EXTERNAL ANTENNA OPENDTC detecting condition:When open circuit occurs in the harness between keyless access CM and rear exterior antenna.Trouble symptom:Ke ...
Check list for interview Check
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Check List for InterviewCHECK• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing customers.Combination Meter / MFD Check List for Interview Date the ...