Subaru Crosstrek Service Manual: Installation

CAUTION:

Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.

1. Install the cowl panel assembly.

CAUTION:

If the cowl panel assembly cannot be installed properly, do not hit or set it forcibly. The claws of the cowl panel or the windshield glass may be damaged.

(1) Hook the claw of the cowl panel on the lower end (1) of the windshield glass.

(2) Align the center protrusion of the cowl panel assembly to the cutout portion of the vehicle side, then install the cowl panel assembly.

(3) Attach the clip and connect the washer hose.

2. Install the arm assembly - windshield wiper. Front Wiper Arm > INSTALLATION">

3. Install the remaining parts in the reverse order of removal.

4. If the washer nozzles have been removed from the cowl panel assembly, adjust the washer spray positions. Front Washer Nozzle and Hose > ADJUSTMENT">

Cowl panel

Removal

Other materials:

Installation
ENTERTAINMENT > AntennaINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer to “CAUTION” of ...

Dtc u0401 invalid data received from ecm/pcm a
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”Failure counter diagnosis of engine control module (ECM)NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the ...