Subaru Crosstrek Service Manual: Installation
EXTERIOR BODY PANELS > Rear Sealing Cover
INSTALLATION
CAUTION:
• If the sealing cover - rear door gets broken, replace it with a new part.
• Apply a butyl tape evenly.
• Attach the sealing cover - rear door, keeping it from becoming wrinkled.
• If the butyl tape is applied unevenly, it will cause water leakage and soiling.
1. Install the sealing cover.
(1) Forcefully push the butyl tape portion to prevent any floating on surface.
(2) When replacing the sealing cover, use the butyl tape.
Preparation items:
Butyl tape: 3M Butyl Rubber 8626 or equivalent
2. Install each part in the reverse order of removal.
NOTE:
Before installation, check the following items.
• Is the lever of the frame assembly - rear door outer is free from deformation?
• Is grease applied sufficiently to the lever joints of the latch and actuator assembly - rear?
• Is the cable of the latch and actuator assembly - rear free from deformation such as fray?
• Is grease applied sufficiently to the cable joints of the latch and actuator assembly - rear?
Removal
EXTERIOR BODY PANELS > Rear Sealing CoverREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL">3. Remove the seal ...
Protector tape Installation
EXTERIOR BODY PANELS > Protector TapeINSTALLATIONApply the protector tape by the following steps.1. REAR QUARTER PROTECTOR (MODELS WITHOUT SIDE GARNISH)(1)Apply the protector tape by aligning it to ...
Other materials:
Adjustment
WIPER AND WASHER SYSTEMS > Rear Wiper ArmADJUSTMENT1. Operate the rear wiper once.2. Align the blade assembly - rear wipe with the marking on the glass.3. If the wiper blade is not aligned with the point mark, perform the removal of the rear wiper to align with the marking. Rear Wiper Arm > R ...
Operation
SECURITY AND LOCKS > Impact SensorOPERATION1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR1. Make an impact sensor setting.(1) Connect the Subaru Select Monitor.NOTE:For detailed operation procedures, refer to “Application help”.(2) Turn the ignition switch to ON.(3) On «Start» ...
Caution
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat ...
