EXTERIOR BODY PANELS > Rear Gate
INSTALLATION
1. REAR GATE PANEL
CAUTION:
The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.
1. Install the hinge - rear gate to the vehicle body.
2. Temporarily install the panel - rear gate to the hinge - rear gate.
NOTE:
When installing, make sure that a uniform clearance is created around the panel - rear gate.
3. Adjust the clearance around the panel - rear gate. Rear Gate > ADJUSTMENT">
4. Tighten the bolts of the hinge - rear gate.
Tightening torque:
25 N·m (2.55 kgf-m, 18.4 ft-lb)
5. Install each part in the reverse order of removal.
Tightening torque:
Rear gate parts: General Description > COMPONENT">
Garnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb)
Arm assembly - rear wiper and motor assembly - rear wiper: General Description > COMPONENT">
Roof spoiler: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
2. REAR GATE DAMPER STAY
CAUTION:
The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.
1. Prevent the panel - rear gate from closing using prop or the like.
CAUTION:
If the prop comes off, operators may get injured and vehicle may get damaged. Make sure to support the panel - rear gate with secure material to prevent injury or damage.
2. Install each part in the reverse order of removal.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
Remote start safety features
For safety and security reasons, the
remote engine start system will prevent
starting (or stop the engine if running) and
sound the horn twice if any of the following
conditions is detected. In addition, the fob
will flash and beep 3 times.
The brake pedal is depressed
A key is in the ign ...
Lifetime fuel consumption resetting
1. Perform the preparation steps according
to "Preparation for initialization"
2. Operate the " " or "
" switch to
select the "Lifetime Fuel Consumption
Resetting" item. Then push the
button.
3. The system will prompt a Yes/No
dialogue ("No" is selected first). To reset
the lifetim ...
Disassembly
MECHANICAL(H4DO) > Chain CoverDISASSEMBLY1. Remove the oil filler cap.2. Remove the engine oil filter and the oil pump union. Engine Oil Filter > REMOVAL">3. Remove the oil pressure switch. Oil Pressure Switch > REMOVAL">4. Remove the engine oil temperature sensor. Engine ...