Subaru Crosstrek Service Manual: Installation

1. REAR DOOR PANEL

1. Put a wooden block on a jack and place the panel assembly - rear door on it.

2. Apply grease to the moving part of door hinges.

3. Adjust the height by the jack, and temporarily install the panel assembly - rear door to the upper hinge - rear door and the lower hinge - rear door.

NOTE:

• When installing the panel assembly - rear door, make sure that a uniform clearance is created around the panel.

• Perform installation while paying attention to the assembly direction of the grommet.

4. Adjust the clearance around the panel assembly - rear door. Rear Door > ADJUSTMENT">

5. Tighten the bolts and nuts of the door hinge and the checker assembly - rear door.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">

6. Install door internal parts in the reverse order of removal.

NOTE:

Before installation, check the following items.

• Is the lever of the frame assembly - rear door outer is free from deformation?

• Is grease applied sufficiently to the lever joints of the latch and actuator assembly - rear?

• Is the cable of the latch and actuator assembly - rear free from deformation such as fray?

• Is grease applied sufficiently to the cable joints of the latch and actuator assembly - rear?

7. Connect the door harness connector, and install the harness grommet.

1. Apply grease to the moving part of door hinges.

2. Adjust the clearance around the panel assembly - rear door. Rear Door > ADJUSTMENT">

3. Tighten the door hinge bolts.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">

Removal

Rear gate

Other materials:

Caution
BRAKE > General DescriptionCAUTION• Wear appropriate work clothing, including a helmet, protective goggles and protective shoes when performing any work.• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly ...

Dtc c0046 body integrated module communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0046 BODY INTEGRATED MODULE COMMUNICATION CIRCUITDTC detecting condition:No CAN signal received from body integrated unit.Trouble symptom:• VDC may not operate.• Hill start assis ...

Dtc b2815 power supply high voltage
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2815 POWER SUPPLY HIGH VOLTAGEDetected when the status for the battery voltage of 16 V or more continues approximately for 5 seconds and is judged to be abnormally high voltage.Refer to DTC B2814 for DTC detectin ...